Australian Federation of Brasilian Jiu Jitsu

RULES

Uniform Requirements

Everything in pictures. AFBJJ follows the IBJJF uniform standards for gi and no-gi — athletes are inspected before stepping on the mats.

Manufacturers and academies: follow the official uniform guideline for approved patch placement, measurements and fabric specifications.

Uniform guideline (PDF)
IBJJF gi patch placement diagram — front, side and back views with authorised patch regions
01

Where patches go

Patches may only be affixed in the highlighted regions. Anything unseamed or outside these zones is removed by gi inspectors.

  • Patches must be cotton and fully seamed
  • Pants patches sit at least 15 cm from the edge
  • Brand tag area allowed at the bottom of the pant legs
IBJJF gi fit and measurement diagram — sleeve, pant, lapel and belt dimensions
02

Gi fit & measurements

The gi top must reach the thigh; sleeves and pants are measured with the arm extended parallel to the ground.

  • Sleeve ends less than 2 cm from the wrist joint
  • Pants end less than 2 cm above the ankle bone
  • Belt 4–5 cm wide, double knot, ends hanging 20–30 cm

Permitted gi colours

Gis must be one uniform colour throughout the top and pants.

White

Royal blue

Black

Inspection measurements

  • Gi lapel thicknessmax 1.3 cm
  • Width of gi collarmax 5 cm
  • Sleeve opening at full extensionmin 7 cm
  • Sleeve end from wrist jointmax 2 cm
  • Pants above ankle bonemax 2 cm
  • Belt width4 – 5 cm
  • Belt tip hang20 – 30 cm

Allowed

  • Cotton or cotton-like woven fabric
  • One single colour: white, royal blue or black
  • Patches of cotton, properly seamed, in authorised regions
  • Women: elastic body-hugging shirt under the gi top
  • Briefs-type undergarments

Not allowed

  • Tops and pants of different colours, or an odd-coloured collar
  • Painted gis (unless an academy/sponsor logo in a patch region)
  • Unseamed patches or patches outside authorised regions
  • Shirts under the gi (men) or any pants under gi pants (men)
  • Torn, mended, wet, dirty or smelly gis
IBJJF no-gi uniform diagram — rash guard and shorts length requirements
03

No-gi uniform

Skin-tight shirt covering the torso to the waistband, plus board shorts or spats in black, white, black and white, and/or your rank colour.

  • Shirt must carry at least 10% of your belt rank colour (or be 100% of it)
  • Shorts cover at least halfway down the thigh, no longer than the knee
  • No pockets, buttons, zippers, drawstrings, plastic or metal
  • Women may wear spats or compression shorts in the same colours

The gi-checker tool

Inspectors use the official gi-checker to verify lapel thickness, collar width, sleeve opening and sleeve length. Watch how it is used so you know exactly what happens at the inspection table.

Uniform inspection

Uniforms are inspected before an athlete competes. Any gi or no-gi attire that fails inspection must be replaced before the athlete is permitted on the mats — bring a spare uniform to every championship.